Ammann APH 5020 - Hand Start; Switching off the Engine

3.5.3 Hand start
•
Set the engine speed control lever to full load.
•
Machines with emergency-stop-connection :
Press emergency-stop-connection.
• Machines with electrical start :
Turn ignition key via position I.
• Move the decompressor (1) lever until it stops in start position.
• Insert the starting crank (2) and turn it with increasing speed.
After starting of the engine,
• release ignition key.
• Set the speed lever to idle.
• Allow the engine to run for 2-3 minutes in order to warm up.
• By misfire ignition return the decompressor lever to its initial
position and repeat steps 1-5.
3.5.4 Switching-off the engine
•
Allow the engine to run a short while on idling.
•
Set the speed lever to stop.
Additionally by electrostart:
• Turn the ignition key to «0» position. (The indicator lamps
should go out.)
• Remove the key.
3. Operation
36
Attention
Machines with electrical starter: Never hand start
with a disconnected battery, this leads to immedi
-
ate destruction of the regulator.
1
B8299005.cdr
2
B8299006.cdr
Attention
Do not switch-off the engine by full load and don’ t
use the decompressor lever.
Danger
At the end of a working day or a break protect the
key from unauthorised access.
Important
The horn will sound if the ignition key is not returned to
the «0» position; a risk of total battery discharge ex-
ists.