•
Firm ly tighten the rear fas te ning nuts and lift the ma chi ne a bit
again.
•
Tense the pro tec tion plate uni formly by tight en ing the ad just -
ment screw. The gap be tween the base plate and pro tec tion
plate should be about 4–5 mm.
•
Lo wer the ma chi ne.
•
Tighten the coun ter-nuts and front fas te ning nuts.
LM75020000-2 HbmG gnu thci dreV nna mmA © 9102/01
3. Ope ra ti on
62
To Next Page
