38
REPAIR SAFETY INSTRUCTIONS
REPAIR SAFETY INSTRUCTIONS
THE FOLLOWING SAFETY INSTRUCTIONS MUST BE OBSERVED BY ALL REPAIRING THE MACHINE!
• Repairs may be carried out by skilled, trained and experienced personnel only and/or by Ammann SERVICE.
• When performing repairs, always use our shop manual. Special instructions for the assembly work are given in individual
chapters of the manual.
• Before putting the machine into operation acquaint yourselves with the machine control as given in the “Operator’s Manual“
and make sure that you understand well all outfit of the machine.
• Do not use the machine if you do not fully understand all controls and until you know how the machine works.
• Know the area where you will work.
• Do not make any redesign or modifications on the machine because you could decrease safety of the equipment.
• Original parts and accessories have been designed especially for this machine.
• Installation and usage of spare parts not supplied by the manufacturer of the machine or not authorized by him can have
negative effects on operational characteristics and safety operation of the machine.
SAFETY PRECAUTIONS WHEN REPAIRING AND INSPECTING THE EQUIPMENT
• Wear work clothe and boots.
• Use gloves when handling oils, fuel or coolant.
• Protect your eyes with goggles or a shield when handling the battery.
• Place the equipment on a flat and firm surface before starting repair. Secure the equipment against spontaneous movement.
• Secure the frame of the equipment and the drum against mutual rotation using a safety pin and a draw bar.
• Before starting work remove the ignition key, disconnect the batteries and let hot parts cool down.
• Attach a warning note “Equipment out of work“ to the steering wheel and leave it there for the duration of service work.
• Wash the equipment thoroughly. If you use steam, do not expose electrical components and insulation directly to stem jet,
or else cover them beforehand.
• Keep all parts absolutely clean when dismantling, mounting, and servicing each assembly. Protect removed parts from getting
soiled.
• Clean the surface of dismantled parts and provide for adequately dust-free working conditions and a needed lay-off area.
• Be careful when handling cleaning agents. Do not use petrol or other easy inflammable materials for cleaning.
• Dry the cleaned parts and immediately cover with anticorrosive protective oil- never install corroded parts!
• Tools, hoists, safety equipment of the supports, and other additional items must be serviceable and in good condition.
• Use hoists and fasteners (ropes, chains) that have sufficient carrying capacity and are in good condition.
• Make sure that there is enough fresh air supply when starting up the equipment in an enclosed area.
• Before placing the equipment into operation make sure there nobody on the equipment or close by. The start of the equipment
must always be announced with an audible alarm , also after any pause in operation before the equipment is restarted. Persons
present on the equipment and dangerously close by must leave the equipment after such alarm has been sounded. Sound
and hand signals and beacons must be also used as specified in the ČSN 27 7012 Standards, Appendix 1.
• Do not adjust moving equipment.
MANUALEQUIPOSPESADOS.COM manualequipospesados@gmail.com
To Next Page
Loading...
