EasyManuals Logo

Ammann AVP 1240 H User Manual

Ammann AVP 1240 H
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
5.5 Maintenance work (Honda-engine)
Attention
Only the maintenance work which has to be performed daily
is included in this operating manual. Please refer to the
engine operating manual and to the maintenance
instructions and intervals listed therein.
5.5.1 Filling up with fuel
Danger
Fill fuel tank only when engine is switched off
No open fire.
No smoking.
Fill fuel tank never in enclosed areas.
Clean the area around the fuel filling socket.
Open the cap and
check the fuel level visually.
If necessary, fill up with fuel
1)
1)
unleaded automotive gasoline
5.5.2 Checking the engine oil level
Park the machine horizontally.
Clean the area around the fuel filler cap.
Open the fuel filler cap.
Check the oil level and
refill up to the edge of the fuel filler cap if necessary.
Check the seal on the dipstick and replace if necessary.
Close the fuel filler cap.
Allow the engine to run for approximately 1 min. and check oil
level again with engine switched off.
5.5.3 Cleaning the air filter element
Attention
Never run the engine without the air cleaner. Rapid
engine wear will result.
Do not allow dust to enter into carburator.
Remove the filter cover (1) and
take out the filter element (2+3).
Check the filter element, replace if damaged.
For slight clogging:
Clean the filter element (2) by tapping lightly or
blow it from inside to the outside with dry compressed air.
For heavy clogging:
Wash the filter element (3) in a non-flammable cleaning
solution and allow to dry thorougly.
Danger
Never use petrol or cleaning solutions with a low flash
point for cleaning the filter element!
Do not smoke in the working area; avoid open fire and
sparks fire and explosion hazard!
Hazard of eyehurts use safety goggles!
Soak the filter element (3) with clean motor oil, squeeze out
excess oil.
Replace the filter element (2+3).
Fit the cover (1) and fasten.
Important
If the intake air has a high dust content, it may be necessary to
clean the air filter several times daily.
5. Maintenance
max. 5 bar
1
2
3
30

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ammann AVP 1240 H and is the answer not in the manual?

Ammann AVP 1240 H Specifications

General IconGeneral
BrandAmmann
ModelAVP 1240 H
CategoryPower Tool
LanguageEnglish

Related product manuals