rev 08.13.12
4/8
www.amp-research.com
AMP RESEARCH BEDXTENDER HD™
BED X-TENDER ASSEMBLY
Using template measure 7” from each end of the
three long tubes and mark with tape. Tape is to be
used as a reference point. (See step 6)
Repeat for the other side.
Adjust the width of the BEDXTENDER to fi t the pre-
installed mounting brackets. To keep tube overlap
constant, adjust each tube so that the gap between
the edge and the tape is the same.
1
2
3
4
5 6
Slide the center tube (With Amp logo) into the center
tube of the 3-tube assembly. Be sure to slide on
Strap Buckle Assembly to center tube of Pivot
Upright Assembly
Insert the top long tube into the top tube of the 3-tube
assembly.
Insert the bottom long tube into the bottom tube of
the 3-tube assembly.
11
11
6
14
14
14
5
Note: Install Strap Buckle Assembly to cen-
ter tube of Pivot Upright Assembly.
Note: Tubes do not need to
be pushed in to taped edge.
Note: If tube joints are tight Soapy
Water can be used.
To Next Page
Loading...
