rev 08.13.12
6/8
www.amp-research.com
AMP RESEARCH BED X-TENDER™
Remove the PT-Screw with a T20 Torx driver.
1
AMP RESEARCH BED X-TENDER™
Install Strap Buckle Insert with the
provided 10/32 x 7mm socket head cap
screw with a 4mm hex key. Repeat for
other strap.
11
10
For Toyota applications the supplied Strap Buckle Insert must be used.
15
16
12
When the BEDXTENDER is at the furthest rear position,
push down on the buckle to insert into tailgate latch. Tighten
straps. To release, pull tailgate handle.
NOTE: Ensure that buckles are properly inserted into
latches by pulling on the straps after both buckles have
been inserted.
To Next Page
Loading...
