www.ampereelectric.co.uk
How to use your e-bike controls
1. Power on and off
2. Up arrow - increases power assist level
3. Down arrow - decreases power assist level
4. Walk assist function
5. Battery charge indicator
6. Pedal assist (PAS) level
7. Front light indicator
Turning On and Off
To turn the e-bike on press and hold button.
To turn the e-bike off repeat the process.
The display will automatically turn off after 10 minutes of inactivity.
Walk Assist
To start the walk assist mode press and hold the button. This will propel the e-bike forward at 4mph
without pedalling.
This will automatically stop when you release the button.
Do not use this feature whilst sat on the e-bike, this will damage the motor and void your warranty.
Front light
To turn your front light on press and hold the button. Repeat this process to turn it off.
To turn the rear light on there is a switch on the side of the light, this is to turn the light on and off.
Power assistance (PAS) level
To increase the level of assistance, press the button.
To decrease the level of assistance, press the button.
Battey charge indicator
The battery charge indicator shows how much charge is in the battery, each segment represents 25% of
the battery charge.
The display is covered under warranty if there is a fault; however, the warranty is invalid in the
following circumstances:
1. If the display has been opened.
2. The connectors become damaged.
3. Cracked screen or housing.
4. Damaged or broken wires.
5. Failure following a crash or collision.
To Next Page
Loading...
