AmpliVox 260 - 3.4.2 MENU; 3.5 Threshold Retention Function

USING THE AUDIOMETER
10 MODEL 260 INSTRUCTION FOR USE
3.4.2. MENU
Pressing and holding MENU accesses the following options. Use the MENU SELECT keys to step through the available
options and then the NO, YES or SIGNAL  keys to select an action or modify a setting. Release of the MENU key then
initiates the action or saves the modified setting and returns to the default display.
Menu Option Description
Switch off?: As described in Section 3.1
Print audiogram?: Press YES and release MENU; then press YES to confirm the print operation or NO to cancel
Clear test?: Press YES and release MENU to clear the displayed test results; stored test results are not
affected
Save audiogram to 1: Use the SIGNAL  keys to select the required storage location and press the YES key to
save the audiogram; then release MENU
Load audiogram no. 1: Use the SIGNAL  keys to select the required storage location and press the YES key to
load the audiogram; then release MENU
Contrast: Adjust contrast using the SIGNAL  keys
Bone masking: Use the SIGNAL  keys to select the AC headset or the optional masking earpiece as the
means of masking
Select phones: This option is only available if a secondary headphone is enabled; use the SIGNAL 
keys to select the required headphone type
FF equiv. speech?: This option is only available if either DD45 or TDH39 is the selected headphone; if
activated, free-field equivalent levels will output to the headphone in speech mode (see
Appendix 1)
Store on 2 of 3?: Use the NO and YES keys to activate automatic storage of a threshold if the responses
made to two out of three test signals are at the same hearing level
Warble to phones?: Use the NO and YES keys to send frequency-modulated tones to the headphones
Set freefield level?: This option provides access to the freefield calibration function; refer to Appendix 2 for
details
Default level: Adjust the default tone presentation level (between 20dBHL and 40dBHL) using the SIGNAL
 keys
2.5dB step size?: Use the NO and YES keys to disable or enable the 2.5dB step size; otherwise step size is
5dB
External talkover?: Select NO to use the internal microphone and YES to use the MIC 1 input
Select printer: Use the SIGNAL  keys to select either the Able AP1300, the Martel MCP8830 printer or
the Sanibel MPT-II printer
Please note: In order to use the Sanibel printer, select ABLE printer in the settings. After
confirming the ABLE printer, the 260 will connect to the Sanibel printer, too.