Page 6 OM023-4 Amplivox 260 Operating Manual
2.4 Audiometer connections
All the relevant accessory terminals and connections are labelled to
ensure correct identification and connection as follows:-
The relevant part numbers are indicated in Section 12.
For connected parts marked * only connect the
accessories supplied with the instrument or supplied by
Amplivox or an Amplivox distributor. These parts have
been tested for use with the Amplivox Model 260
Diagnostic Audiometer for compliance with the standards
IEC 60601-1 and IEC 60601-1-2. The use of accessories
other than those specified may compromise compliance
with these standards. For other sockets see Appendix 4.
2.5 Data transfer to a printer
Please refer to Appendix 4 for important information
regarding the connection of non-medical electrical
equipment to medical electrical equipment
The audiometer can be upgraded with an option to allow connection to
one of two designated portable thermal printers for printing air conduction,
bone conduction and ULL test results (see Section 3.8). You must use the
designated cable for each printer, which is supplied with this option.
To Next Page
Loading...
Need help?
General
