AmpliVox 270 - Data Transfer to a Printer; Data Transfer to a Computer; Line In;Out Connection (Audio)

OM020-9 Model 270 Operating Manual Page 5
2.5 Data transfer to a printer
Please refer to Appendix 4 for important information
regarding the connection of non-medical electrical
equipment to medical electrical equipment
The audiometer can be upgraded with an option to allow connection to
one of three designated portable thermal printers for printing air
conduction, bone conduction, speech and ULL test results (see 3.9). You
must use the designated cable for each printer, which is supplied with this
option.
Upon receipt of the printer it must be initially charged for a minimum of 15
hours prior to use.
2.6 Data transfer to a computer
Please refer to Appendix 4 for important information
regarding the connection of non-medical electrical
equipment to medical electrical equipment
The audiometer is supplied with software to allow connection to a
computer for the transfer of test results (see Section 3.10). You must use
the designated USB cable which is available from Amplivox (see Section
12).
2.7 Line in/out connection (audio)
Please refer to Appendix 4 for important information
regarding the connection of non-medical electrical
equipment to medical electrical equipment
The Model 270 has audio line in/out connections for CD or tape player
input (e.g. for recorded speech testing) and amplifier output.
Line out connections are switched on only when FREEFIELD is selected.
The following connections apply to both LINE IN and LINE OUT.