3.8 Loading audiograms from internal memory
Press the OPTIONS key and then press NEXT repeatedly until “Load
Audiogram no ” appears on screen. Select the required audiogram (1-12),
using the UP key and then press the LOAD key. Press the QUIT key once
confirmation that the thresholds have been retrieved appears on screen.
3.9 Printing audiograms
Three designated thermal printers (the Able AP1300 or the Martel
MCP8830 or the Sanibel MP-II) are available as options for use with the
Model 270 audiometer. The correct printer must be selected (use the
MENU options described in Section 3.5.2 to make this selection).
Connect the audiometer to the printer with supplied printer cable (refer
to Section 2.5 of this operating manual for printer set-up). Insert the 6-
pin mini DIN into the DATA socket on the back of the audiometer.
Insert the terminal plug into the socket at the back of the printer. Note
that the printer cables for the Able printer (stock number A105)
and Martel printer (stock number A104) and the Sanibel Printer
(A101) are not compatible.
Ensure the printer is switched on and ready to print.
Load the desired audiogram as described in 3.8; to print the current
audiogram ignore this instruction
Press the PRINT key. On the prompt “Is printer ready?” press the YES
key. The audiogram will then print.
3.10 Data transfer to NOAH or AudiView
To transfer test results stored within the audiometer to a NOAH database the
Amplivox NOAH Audilink software must be installed on to a computer.
Alternatively, Amplivox AudiView allows data to be transferred to a computer
and subsequently viewed, annotated & printed. This software is supplied on a
CD which includes this operating manual.
Refer to the installation & operating instructions provided with NOAH
Audilink or AudiView for further details.
To Next Page
Loading...
