Need help?Do you have a question about the Amprobe INSP-3 and is the answer not in the manual?
General| Brand | Amprobe |
|---|---|
| Model | INSP-3 |
| Category | Test Equipment |
| Language | English |
Controls for power, mode selection, and test current settings.
LEDs for load status and the main LCD test display.
Details on the power cord receptacle and battery compartment.
Meanings of symbols for voltage, insulation, CE, and safety standards.
Symbols indicating battery power and proper waste disposal.
Inspect tester and verify voltage function before and after measurements.
Avoid grounding, explosive atmospheres, moisture, and observe voltage limits.
Use hand/finger barriers and avoid contact with exposed circuit elements.
Efficient data presentation on a single screen for time-saving.
Confirms wiring performance against electrical code for voltage drop.
Detects issues like bad splices, incorrect wiring, and poor ground quality.
Assesses line voltage and ground quality for reliable operation.
User-selectable 10, 15, 20 amp loads for comprehensive testing.
Tests the proper tripping and operation of GFCI and AFCI devices.
Clear failure indicators and circuit protection during tests.
Step-by-step instructions for connecting and testing outlets.
Specific guidance for testing GFCI/AFCI breakers and manual trip activation.
Explains voltage, polarity, voltage drop, and ground impedance readings.
Details on RMS voltage and polarity status display.
Defines voltage under load and acceptable operating ranges for devices.
Explains voltage drop and its causes, referencing electrical code recommendations.
Identifies common causes such as bad splices, loose connections, and undersized wires.
Notes issues with aluminum wiring and worn switch/breaker contacts.
Clarifies performance expectations for 15 amp systems versus 20 amp systems.
Evaluates the quality of the outlet's ground connection and resistance.
Detects wiring errors in three-wire outlets.
Recommendations for testing GFCI/AFCI circuits, including breaker checks.
Specifies load simulation capabilities and operating voltage range.
Details battery power, GFI/RCD/AFCI trip characteristics.
States measurement accuracy and operational temperature limits.
Steps to isolate problems by checking battery, power cord, and instructions.
Procedure for replacing the 9V alkaline battery.
Guidelines for cleaning the tester's exterior with mild solutions.
To Next Page
