22
The output is enabled or disabled by pressing the "OUTPUT (ON/OFF)" key. The PPS-2322 output is enabled or
disabled by selecting the channel/s and pressing the "OUTPUT (ON/OFF)" key.
4.7 TRACKING OPERATION (PPS-2322)
The PPS-2322 has the ability of tracking since it has two outputs. When the tracking mode is enabled, the
annunciator "RMT" is on. The output of channel two is identical (in sync. with) to channel one and is controlled
by channel one. For instance, a voltage increase in channel one would also cause a voltage increase in channel two.
4.8 RANGE OPERATION (PPS-1326)
The model PPS-1326 has two (HI/LO) operating ranges. These ranges are controlled by {RESERVED FOR
OPERATING PROCEDURES}. The LCD displays "LO" when the low range is active or "HI", when the high
range is active. All other operations on the PPS-1326 are identical to other models. For more information on
operating range characteristics, please refer to section 3.2.
4.9 AUDIBLE SIGNAL
The power supplies have an audible indicator, which allow monitoring of operating conditions. When functions are
activated or parameters set, the audible signal will sound. Should the protection modes be activated an audible
signal will sound, indicating a change in an operating mode has occured. The LCD and annunciators will indicate
the condition. This feature can also be disable or enabled by pressing the "BEEP" key.
To Next Page
Loading...
Need help?
General