41
COMMAND DEFINITION
ADDRESS Sets the address of the PPS
CALCHNL Turns the calibration mode on or off.
IFS Sets the fullscale current for calibration.
IHIFS Sets the high fullscale current for calibration
(PPS- 1326 series only).
ILOFS Sets the low fullscale currentfor calibration
(PPS- 1326 series only).
IOFF Sets the current offset value in calibration.
ISET Sets the current
ISET1 Sets the current to channel one
(PPS-2322 series only).
ISET2 Sets the current to channel two
(PPS-2322 series only).
OCP Set the overcurrent protection.
OUT Set the output on or off.
OUT1 Sets the output of channel one on or off
(PPS-2322 series only).
OUT2 Sets the output of channel two on or off
(PPS-2322 series only).
OVSET Set the overvoltage protection
OVSET1 Set the overvoltage protection value for channel one
(PPS-2322 series only)
OVSET2 Set the overvoltage protection value for channel two
(PPS-2322 series only)
RANGE Sets the low or high range of the PPS-1326 series.
TRACK Sets the tracking mode of the PPS-2322 series.
VFS Sets the fullscale voltage for calibration.
VOFF Sets the offset voltage for calibration.
VSET Sets the voltage
VSET1 Sets the voltage to channel one
(PPS-2322 series only).
VSET2 Sets the voltage to channel two
(PPS-2322 series only).
DSP Enable/Disable the display message on the LCD module
To Next Page
Loading...
Need help?
General