US/50 User's Guide 3
Overview
Power Section
Use the Power Section to select the treatment modality, activate the main ac power
and set the treatment duration. When the treatment is complete the power will
shut off and a bell will sound.
Low Volt AC Stimulator Modality Section
Set the intensity and monitor the output of low volt ac stimulation with the controls
and connectors in this section of the panel. Select either pulsation, tetanize, or
surge output using the Output Mode control. Regulate the frequency of the pulses,
or adjust the duration of the surge, with the Pulse/Surge Rate control.
Ultrasound Modality Section
Set the intensity and monitor the output of ultrasonic energy with the controls,
connectors and meter dial in this section of the panel. Select either non-interrupted
output or a specific interrupted rate using the Interrupted Output slide control.
Combine ultrasound output with low volt ac stimulation using the Combination
switch.
To Next Page
