Why doesn't the chamber temperature rise in Amsco Laboratory Equipment?
If the chamber drain line or strainer is plugged in your Amsco Laboratory Equipment, make sure to clean the line or strainer. This should help the chamber temperature rise to the correct setting.
What to do if chamber pressure drops in Amsco EAGLE 3043?
If you notice the chamber pressure and temperature dropping during a cycle in your Amsco Laboratory Equipment, the chamber drain line or strainer might be plugged. Cleaning the line or strainer should resolve this issue.
How to troubleshoot no power on Amsco EAGLE 3043 Laboratory Equipment?
If your Amsco Laboratory Equipment shows no sign of power, first, ensure that the facility power source is active and turned on. Then, check the POWER switch on the equipment itself to make sure it is in the ON position.
Why is there water in Amsco EAGLE 3043 after cycle?
If you find water in the chamber or door channel at the end of a cycle in your Amsco Laboratory Equipment, there are several possible causes: * The drain may be plugged or clogged, so clean the drain. * The steam separator/strainer may be plugged, so clean it. * The drain line check valve may be defective, so replace it.
Why are wrapped goods wet in Amsco Laboratory Equipment?
If wrapped goods are wet after completing a cycle, or there is excessive vapor in the chamber when the door is opened on your Amsco Laboratory Equipment, the dry time might be too short for the load type. Try increasing the setting for dry time.
What causes high pressure and low temperature in Amsco EAGLE 3043 Laboratory Equipment?
If, during the sterilize phase, the pressure is too high and the temperature is too low in your Amsco Laboratory Equipment, it might be due to air trapped in the chamber because of a clogged strainer or drain. Clean the strainer inside the chamber, and flush and clean the drain line and traps.
What to do if I can't select a cycle on Amsco EAGLE 3043 Laboratory Equipment?
If you are unable to select a cycle on your Amsco Laboratory Equipment, check if the chamber door(s) are open. Close and lock the door(s). The control will beep three times if the door is open when a cycle is selected.
Why is steam blowing out of Amsco EAGLE 3043 Laboratory Equipment?
If steam blows out around the door during the sterilize phase of your Amsco Laboratory Equipment, the door gasket may be worn or defective. Consider replacing it.
Why isn't the jacket pressure rising in Amsco EAGLE 3043 Laboratory Equipment?
If the jacket pressure does not rise to the required level in your Amsco Laboratory Equipment, consider the following: * Ensure the steam supply hand valve is open; if not, open the valve. * There may be a flood condition or the steam supply solenoid valve is closed. * The steam supply may be less than 50 psig (3.52 kg/sq.cm) dynamic; check the supply pressure and increase if necessary.
Covers burn, shock, slipping, and explosion hazards during operation and maintenance.
Cautions against using abrasive materials and improper piping support.
Checklist to ensure installation is complete and correct per equipment drawing.
Procedures for filling and starting the optional electric steam generator.
Settings adjustable via dip switches for sterilizer functions.
Operator settable adjustments for temperature, language, and lab mode.
Setting sterilizer time/date and automatic utility shutdown/restart times.
Daily cleaning and weekly flushing/checking procedures for the sterilizer.
Monthly lubrication and quarterly gasket checks.
Maintenance for optional generator and tasks performed as needed.
A chart listing common problems, probable causes, and corrections for sterilizer malfunctions.
Lists of spare parts for specific sterilizer series, including part numbers.
List of publications associated with the use and maintenance of Series 3000 Sterilizers.
General| Brand | Amsco |
|---|---|
| Model | EAGLE SERIES 3043 |
| Category | Laboratory Equipment |
| Language | English |
To Next Page