EasyManua.ls Logo

Amsta AMCLI180E - Repair, Troubleshooting, and Environmental Data; Refrigerant GWP and Power Consumption Data; Common Problems and Troubleshooting Solutions

Amsta AMCLI180E
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN-25
PLANETARY WARMING POTENTIAL, PRP (kgCO
2
eq)
3
Leaking refrigerants accentuate climate change. In the event of a leak, the impact on global
warming will be all the more limited as the global warming potential (GWP) of the refrigerant
is low. This device uses a refrigerant with a GWP equal to 3. In other words, if 1 kg of this
refrigerant is released into the atmosphere, its impact on global warming will be 3 times
greater
than that of 1 kg. of CO
2
, over a period of 100 years. Never attempt to intervene in
the
refrigeration circuit and to disassemble the parts yourself and always contact a professional.
ELECTRICITY CONSUMPTION IN "THERMOSTAT OFF"
MODE (W), P
TO
-
POWER CONSUMPTION IN "STANDBY" MODE (W)
P
SB
0.84
For any further information, please contact:
Schneider consumer group, 12 rue Jules Ferry, 93110 Rosny-sous-bois, France
REPAIR :
Problem
To analyse
Does not work.
The circuit breaker or fuse is blown.
Wait 3 minutes, then turn the device back on.
The batteries in the remote control are exhausted.
The plug is not plugged in correctly.
Requires u se of the device in an ambient temperature of
7 °C to 35 °C.
Works only for a few
moments.
If the set temperature is close to room temperature.
Air outlet blocked by an obstacle. Remove this obstacle.
Works, but does not
cool.
Door or window.
Another heater is working (heater, lamp, etc.).
The air filter is dirty. Clean it up.
Clogged air outlet or intake.
Does not work and the
alarm light comes on.
Drain the water into a container using the drain hose on the
back of the appliance. If it still does not work, consult a
qualified technician.
The display shows E1
or E2.
E1 means that the room temperature sensor is defective.
E2 means that the tube temperature probe is defective.
Contact the after-sales service.
Dehumidification does
not work.
Requires u se of the device in an ambient temperature of
over 17 °C.