AMX AXT-CA10 - Lighting; MAX - Integrated Content Servers by AMX

Introduction
8
DXP-PRO v1.1 - Programmer’s Guide
Lighting
MAX - Integrated Content Servers by AMX
MAX-MMS and MAX-IMS media servers are supported for G4 touch panels only, via Ethernet
control.
DXP-PRO treats these devices essentially the same as any other Ethernet-controlled device (such as
MP3 players). To add MAX servers to a DXP-PRO project be aware that:
 The MAX-MMS and MAX-IMS servers are controlled only by Ethernet and must be
used with AMX G4 touch panels.
 The MAX-AVM A/V Module(s) connected to a MAX-MMS server must each be set to a
unique zone number (per server).
 Refer to the MAX-MMS and MAX-IMS Installation Guides (available online at
www.amx.com) for details.
• Integra RDV1
• Kenwood DV5900M
• Marantz DV8400
• Marantz PMD930
• Marantz VC5400
• Onkyo DVS939
• Philips Pro DVD 175
• Sony DVP-CX777ES
• Yamaha DVD-C940
• Yamaha DVD-S2300MK2
•AMX ALD-D48
• AMX Radia
• Clipsal C-Bus Note: The Clipsal C-Bus and Dynalite lighting systems
(DXP-PRO v1.1 or higher) are primarily used outside the U.S.
• DynaLite - Any DTK Series
• Lehigh DX2
• LiteTouch 5000LC
• Lutron GRAFIK Eye
• Lutron Homeworks Interactive
• Lutron RadioRA
• Vantage Qlink
• Tridonic DALI Note: The Tridonic Lighting System type does not have
feedback; therefore, the buttons in DXP will not depress to
reflect feedback.
• Other Ethernet - user supplied/modified light
• Other Serial - user supplied/modified lights.axi
• MAX-MMS MultiMedia Servers (MAX-MMS125/200/300/350/400M/900M)
• MAX-IMS Integrated Music Servers (MAX-IMS500/1000/1500/2500)