Building-in Dimensions A×B (mm)
Weight and Dimensions are approximate. Because we continually strive to improve our
products we may change specifications and designs without prior notice.
The device meets the requirements of Regulation 2014/35/EU as well as the
applicable standards EN60335-1:2012+AC:2014+A11:2014; EN60335-2-6:2015;
EN 62233:2008
Manufacturer:
Zhongshan Youlong Kitchen Appliances Co., Ltd
Add.: Qiangye South Road Maxin Industrial Zone, Huangpu, Zhongshan, Guangdong, P.R.
China
Coorpration/Customer Support:
C/O E Gate Germany GmbH Marzahner Str. 34 D-13053 Berlin Germany
Installation
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved
around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant
work surface material to avoid larger deformation caused by
the heat radiation from the hotplate. As shown below:
To Next Page
