ANALOX Sub Aspida - Page 31

ADM, HBOT & Sub Aspida
User Manual Int. Approved
Document ref: PSA-811-14 June 2017 Page 29 of 43
Copyright © 2017 Analox Ltd. All Rights Reserved.
Commercial in Confidence
2) Gently remove the sensor cap as shown in Figure 17.
Figure 17 - Remove the sensor cap
WARNING: Do not touch the inside of the (instrument other than as noted in these
instructions) without appropriate anti-static precautions.
3) Locate the alignment rib on the sensor extraction tool as shown in Figure 18.
Figure 18 - Locate the alignment rib