Need help?Do you have a question about the Analytik Jena multi N/C 2100S and is the answer not in the manual?
General| Combustion Temperature | Up to 950°C |
|---|---|
| Calibration | Multi-point calibration |
| Software | multiWin software |
| Type | Total Organic Carbon/Total Nitrogen Analyzer |
| Detection Limit (TC) | 0.003 mg/L |
| Sample Type | Liquid samples |
| Measurement Principle | High-temperature catalytic oxidation |
| Detection Method | NDIR for TC, chemiluminescence for TN |
| Analysis Time | 3-5 minutes per sample |
| Carrier Gas | Oxygen or air |
| Power Supply | 50/60 Hz |
| Detection Limit (TN) | 0.015 mg/L |
General notes about the Double Furnace Solids Module's function and compatibility with analyzers.
Specifies the designated purpose of the Double Furnace Solids Module for solids analysis.
Details the parts of the solids module involved in preparing samples for analysis.
Describes the combustion furnace and how the solids module integrates with it.
Lists the necessary accessories required for operating the Double Furnace Solids Module.
Step-by-step instructions on how to fill the combustion tube with catalyst and quartz wool.
Guides the user through physically installing the solids module into the combustion furnace.
Steps to prepare the analyzer and solids module before starting a measurement.
Instructions for tempering sample boats to ensure accurate analysis results.
Detailed procedure for conducting sample analysis using the solids module.
Outlines maintenance tasks and intervals for the combustion tube component.
Details maintenance tasks and intervals for the furnace lock mechanism.
To Next Page
