Need help?Do you have a question about the Analytik Jena multi N/C 3100 and is the answer not in the manual?
General| Power Supply | 230 V, 50/60 Hz |
|---|---|
| Measurement Principle | High-temperature catalytic combustion |
| Detection Method | NDIR (Non-Dispersive Infrared Spectroscopy), CLD (Chemiluminescence Detector) |
| Sample Types | Liquid, Solid |
| Carrier Gas | Oxygen |
Detailed safety guidelines for handling concentrated ortho-phosphoric acid during analysis.
Explains the process of measuring Total Inorganic Carbon (TIC) using acid addition and CO2 detection.
Details the setup of the Erlenmeyer flask and TIC head for the reaction.
Instructions on setting the carrier gas flow using the "O2" needle valve and measuring glass.
Describes the process of metering phosphoric acid using the metering pump and valve.
Explains the function of the drying tube, water traps, and halogen trap for gas purification.
Identifies the power input, gas output, and carrier gas connections on the module.
Steps for connecting the manual TIC solids module to the basic unit analyzer.
Detailed procedure for conducting a TIC measurement, including sample handling and parameter settings.
Lists the recommended frequency for various maintenance tasks like cleaning and component replacement.
Step-by-step guide on how to replace the desiccant in the drying tube.
Instructions for replacing the copper and brass wool in the halogen trap.
Details the process for rinsing and drying the TIC reactor (Erlenmeyer flask) after use.
To Next Page
