3. Pas level and Walking Assistant Mode
In the power-on state, the pas position is 5 segments of LED display. By
adding and subtracting keys, the electric vehicle assist gear position is
switched, and the motor output power is changed. The instrument output
power range is 0-5 oas. (The pas range is adjustable, after starting. The
power assist file defaults to 1 file), and the LEDs on the left side of the
booster gear are displayed in order from bottom to top. Pressing and holding
the minus button does not release, it will enter the walking assistant mode,
at which point all the LEDs will flash. Release the minus button to exit the
waking assistant mode and the pas LED stops flashing. (any pas level can
be entered) The walking assistant mode and pas display are shown in Pic
6-3:
Pic 6-3
During working, press Minus to
decrease pas, and long press to
start Walking Assistant Mode
To Next Page
Loading...
