INSTALLATION
46ST ver. 4.1 – 46ST FS ver. 4.1.F
Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the position
numbers in the parts list.
Tools required for the installation:
Allen key (4 mm).
Allen key (5 mm).
Allen key(6 mm).
Ø 8.5 mm. (11/32”) drill.
5 pcs. M8 (5/16”) bolts and nuts (length depending on deck thickness).
5 x large washers or backing plate.
Ring spanner to match nuts.
Bedding compound.
1. Drill bolt holes Ø8,5mm (11/32”) using the winch template. Be sure that no dust comes in
contact with the winch, while drilling.
2. Remove screws (1).
3. Remove self-tailing arm (2) and drum (4).
4. Apply a light coat of bedding compound, ensuring that each bolt hole is bedded. Keep
drain grooves clear.
5. Fasten lower base (19) into place using 5 pcs. M8 (5/16”) bolts. Use large washers or a
backing plate.
6. Assemble in reverse order.
7. Check that the winch is functioning correctly:
The drum should operate smoothly, by turning the drum clockwise by hand.
The drum must not turn when trying to turn the drum anti clockwise.
While turning the winch handle clockwise the drum should turn slowly.
While turning the winch handle anti clockwise the drum should turn fast.
To Next Page
Loading...
Need help?
General
