PAGE 10
2.3.5
Transmitter Signal Connections
The Instrument is shipped with sensors pre-wired and calibrated. In the event that the
wires are removed for installation, they should be re-attached as shown below.
Access to the terminal blocks is gained by removal of the two right side thumbscrews on
the display board, and pivoting the board away. If leads are shortened, they should be
re-tinned before wiring.
Pressure Transmitters
RSP RSV
TPP TFP
TRANSMITTERS CAN BE POWERED
INTERNAL OR EXTERNAL
INPUT CARD 56001-D1
56014-E88
INTERNAL POWER SUPPLY
LOOP EX
LOOP IN
INPUT CARD 56001-D3
56014-E87
EXTERNAL POWER SUPPLY
LOOP IN
LOOP IN
To Next Page
Loading...