Continuum Power Supply Reference
7
Input Power Connection
AC Power Connection
(AC 50, AC 85, AC 50-U, AC 85-U, PS 120/240 AC 25)
All the PS 120/240 power supply modules are powered by an external AC source.
This source is connected via three screw terminals located inside the cover at the
bottom of the unit as shown below. The module should receive power from its own
independent, 120-240 VAC, 50 or 60 Hz, 100 VA, unswitched circuit.
In order to access the connector you must remove the plastic cover from the case.
Press both cover removal tabs inward simultaneously:
Do not apply excessive force when connecting the AC wires to the
terminals. Be careful not to twist the wire bundle after it is
connected. This connector cannot be used as a strain relief!
Bottom of Case
Press These Tabs
Pull Cover Upward
with Tabs Depressed
GND
(green)
HOT
(Black)
NEUTRAL
(white)
AC
POWER
GND
(See next page)
To Next Page
Loading...