12
Andover Controls Corporation
External Power Indicator Connection
All Continuum power supply modules include a connector for an external LED power-
on indicator. The signal from this connector is active when the power supply is turned
on and receiving input power (AC or DC).
Connection is via a two pin removable female Molex connector # 14-56-7022 (not
supplied). Wire the external LED as follows:
An optional cable assembly is available. Andover Controls part number 01-0010-422
is a 2 foot (60 cm) cable that includes the LED and connector.
Bottom of Case
LED
(+)
LED
( )
External
LED
To Next Page
Loading...