Andover Controls CONTINUUM - DC Input Power Connection (PS -48 DC 50)

10 Andover Controls Corporation
Earth
Ground
VIN
(+)
VIN
( )
48VDC
System
GND
(See page 7)
DC Input Power Connection (PS –48 DC 50)
The PS –48 DC 50 power supply module is powered by an external 2 Amp
-48VDC
Nominal Input voltage -15% / +10%
UL listed source. This source is connected via
three screw terminals located at the bottom of the unit as shown below.
ATTENTION: For all applications, the external power source must be listed for
to UL1481.
In order to access the connector you must remove the plastic cover from the case.
Press both cover removal tabs inward simultaneously:
Press These Tabs
Pull Cover Upward
with Tabs Depressed