Need help?Do you have a question about the andrews 29/120 and is the answer not in the manual?
General| Voltage | 230 V |
|---|---|
| Pressure Rating | 8 bar |
| Thermostat | Adjustable |
| Category | Water Heater |
| Model | 29/120 |
| Capacity | 120 Litres |
| Material | Steel |
Outlines manufacturer and supplier duties for product safety and user information.
Step-by-step guide for assembling flue collector hood and related components.
Specifies requirements for the physical placement of the water heater.
Details flue connection, material, and installation recommendations for safe exhaust.
Outlines requirements for adequate air intake and ventilation for proper operation.
Procedures for connecting water inlet, outlet, and drain lines.
Installation procedures for systems operating without an open vent.
Step-by-step guide for igniting the pilot and main burner.
Procedure to verify and adjust the main burner's gas pressure.
Safety check to ensure flue gases are vented correctly.
Guidance on explaining operation, safety, and maintenance to the end-user.
Explains the functional steps of the water heater during use.
Details the safety feature that shuts off gas in case of overheating.
Describes a phenomenon affecting water temperature distribution within the tank.
Instructions for cleaning and maintaining the burner components.
Procedures for checking and servicing the gas control valve.
Guide for cleaning and inspecting the internal flue pathways.
Process for removing scale and deposits from the water storage tank.
Inspection and replacement of sacrificial anodes to prevent corrosion.
Procedures for checking and servicing the safety relief valve.
Steps for removing and replacing the gas control valve unit.
Procedures for replacing temperature control components.
Steps for replacing pilot assembly and associated parts.
Instructions for removing and fitting a new burner assembly.
Troubleshooting steps when the heater fails to produce hot water.
Actions to take if the pilot light does not ignite.
Diagnosing issues when the pilot light extinguishes.
Troubleshooting steps when the main burner fails to ignite.
Investigating causes for repeated thermocouple failure.
Diagnosing and resolving issues related to poor combustion.
Troubleshooting steps for an excessively hot water output.
Diagnosing and resolving issues with insufficient hot water temperature.
Steps to address low volume of hot water supply.
Identifying the cause of water leaks or condensation from the heater base.
Addressing scale formation causing kettling noise in the heater.
To Next Page