To Next PageTo Next Page
Need help?Do you have a question about the andrews 63/62 and is the answer not in the manual?
Provides general information about the water heater's design and safe operation.
Lists relevant British Standards and Codes of Practice for installation.
Outlines responsibilities under Health and Safety Regulations 1993.
Discusses the heater's resistance to Legionella bacteria.
Presents technical specifications for the Standard Range models.
Presents technical specifications for the Hi-Flo Range models.
States legal requirements for installation by qualified personnel.
Guidance on selecting a suitable installation location for the heater.
Details requirements for connecting the gas supply.
Instructions for connecting the electrical supply for auto ignition units.
Recommendations for flue installation according to standards.
Details air supply and ventilation requirements for installation.
Information on water quality, anode protection, and water treatment.
Explains the Hydrojet system for water connections.
Details vented systems for Standard Range water heaters.
Instructions for fitting and operating Correx powered anodes.
Details unvented systems for Standard Range water heaters.
Details vented systems for Hi-Flo Range water heaters.
Details unvented systems for Hi-Flo Range water heaters.
Instructions for commissioning Standard Range permanent pilot models.
Instructions for lighting the burner for Hi-Flo Range permanent pilot models.
Instructions for lighting the burner for Standard Range auto ignition models.
Instructions for lighting the burner for Hi-Flo Range auto ignition models.
Explains user instructions and advice for safe operation.
Safety warnings and precautions for users.
General operation for Standard Range models.
Operating sequence for Hi-Flo Range permanent pilot models.
Operating sequence for Auto Ignition models.
Explains the function of the Energy Cut-Off device.
Discusses and explains temperature stratification issues.
General guidance on servicing by qualified personnel.
Instructions for checking and cleaning the burner assembly for Standard Range.
Instructions for checking and cleaning the burner assembly for Hi-Flo Range.
Servicing the gas control valve for Standard Range.
Checking and cleaning flue ways for Standard Range.
Procedure for cleaning the storage vessel and descaling.
Maintenance and inspection of magnesium anodes.
Instructions for replacing the gas control valve in Hi-Flo Range.
Fault finding for pilot issues and water heating.
Fault finding for poor combustion and temperature issues.
Fault finding for auto ignition units (Standard Range).
Fault finding for auto ignition units (Hi-Flo Models).
Parts list and illustrations for specific Standard Range models.
Parts list and illustrations for Standard Model 84/87.
Parts list and illustration for Hi-Flo Model 32/143.
Parts list and illustration for Hi-Flo Models 65/173 and 81/264.
Detailed parts list for Hi-Flo Range models.
Illustration of the Unvented Systems Kit for Standard Range.
Illustration of the Unvented Systems Kit for Hi-Flo Range.
Illustration of the 24 Volt Auto System Kit B217.
Illustration of the 24 Volt Auto System Kit B258.
Features of the Honeywell integrated controls system.
General troubleshooting guide for operational and display issues.
Guide to accessing, navigating, and using the Honeywell control service mode.
Understanding error codes, their definitions, and history.
Procedures for resetting soft and hard lockouts.
Detailed troubleshooting for water heater not operating due to sensor faults.
Troubleshooting pilot ignition and flame signal issues.
Troubleshooting main burner not lighting.
Steps for removing and inspecting the main burner and pilot.
Step-by-step guide for replacing the control board.
Steps for removing and inspecting flue baffles.
Steps for removing and inspecting anode rods.
General| Brand | andrews |
|---|---|
| Model | 63/62 |
| Category | Water Heater |
| Language | English |
