8. Assemble the anchoring flange into the tank flange to
securely seal the liner to the tank, carefullly install the
screws snug, finally remove the temporary nails and attach
the last two screws. Fig. 8
Fig. 8
9. For maximum water flow, it is recommended that the largest
tubing size for your pump is used. If using 1 in. ID tubing,
proceed to step 10. If using 1-1/2 in. ID tubing, cut the
adapter as shown using a hacksaw. Fig. 9
Fig. 9
10. Assemble coupler, gasket and adpter to tank. Fig. 10
Fig. 10
11. Put bio media balls with bag inside tank Fig. 11
Fig. 11
s with
PLEASE CALL 1-800-553-5605 BEFORE RETURNING TO THE STORE.
WWW.ANJONMFG.COM
To Next Page