EN EN
11 12
2.
Prepare the Remote Control
The remote control comes with two coin batteries.
①
For rst-time use, remove the battery insulation tabs to activate the
remote control batteries.
②
To replace the batteries, slide open the battery compartment, insert
new batteries (matching the polarity (+/-) indicated), and close the
battery compartment.
3.
Get Started
①
For rst-time use, fully charge the built-in battery using the provided
adapter.
②
Hold for 2 seconds on the projector to turn it on.
③
Turn the device towards a suitable projection surface or wall.
④
Adjust the focus by rotating the focus adjusting knob.
To Next Page
Loading...
