To Next PageTo Next PageWhy is my AnkerMake 3D printer producing spaghetti?
The spaghetti effect in AnkerMake 3D Printers can occur if the filament is entangled, the initial layer of the print model isn't sticky, or partial warping of the print model causes the nozzle to collide and move the print model.
What causes layers to dislocate on AnkerMake 3D prints?
Layers can dislocate on AnkerMake 3D prints if the acceleration and jerk speed parameters are set beyond the optimal printing range. It can also be caused by mechanical movement during the printing process, or if the small-angle suspended surface structure of the print model isn't conducive to high-speed printing.
Why is my AnkerMake 3D printer flowing or falling?
Flowing or falling in AnkerMake 3D printer prints can happen for several reasons. The filament might be wet, leading to poor print quality. The E-axis retraction distance could be too short, or the retraction speed too slow. The printing temperature might be too high, causing the filament to flow and fall due to gravity during idle driving. The floating distance might be too long, causing the filament to fall due to gravity. Lastly, the nozzle could be worn.
General| Build Volume | 235 x 235 x 250 mm |
|---|---|
| Filament Diameter | 1.75 mm |
| Nozzle Diameter | 0.4 mm |
| Max Print Speed | 500 mm/s |
| Connectivity | Wi-Fi, USB, Ethernet |
| Maximum Nozzle Temperature | 300°C |
| Maximum Bed Temperature | 100°C |
| Frame Material | Aluminum |
| Power Supply | 350W |
| Layer Resolution | 0.1 mm |
| Supported Filaments | PLA, ABS, PETG, TPU |
| Touchscreen | 4.3-inch |
| Camera | Yes |
