The blades are very sharp. Never touch with bare hands. Always hold the blade
attachment firmly by the plastic
housing.
•
Surfaces could be damaged! Do not use any caustic or abrasive cleaning agents
or scouring sponges to clean the device.
1. Make sure that the device is disconnected from the mains
power.
2. If required, wipe down the motor unit (5) with a slightly damp
cloth.
Then dry it
with a soft
cloth.
3. Rinse the accessories which have been used with clear, warm water and some mild
detergent.
The cups / soup jug (10, 12, 3) along with the lids can
be
cleaned in the dishwasher.
4. Allow all parts to dry
completely
.
5. Reassemble the device.
6. Store the device in a cool, dry place which is protected from
direct
sunlight and is
out of the reach of children and animals.
NOTE: The plastic parts may suffer discoloration over time. However, this does not have
any negative effect on either your health or the performance of the appliance.
If the device does not work properly, first check whether you are able
to
rectify the
problem yourself.
Do not attempt to repair a defective electrical device yourself! If the device will
not switch ON, check the
following:
•
Is the mains plug inserted in the plug socket correctly?
•
Is the plug socket defective? Try another plug socket.
•
Has the fuse of your main connection been activated?
•
Is the blade attachment (4) screwed on correctly?
•
Is the blade attachment (4) positioned in the motor unit (5)
correct
ly? The device
can only be switched on if the blade attachment (4) has been positioned and
locked in place correctly in the electric motor unit (5). The arrows marked on the
blade attachment (4) and the
motor
unit (5) must align to one another.
CLEANING
CAUTION: The stainless steel blades are very sharp.
Handle these components with caution. Ensure you keep your fingers clear of the cutting edges when
handling these items. Take care when washing the blades. Never leave them in a sink or washing bowl
with other items. Always wash separately
1. Remove the supply cord plug from mains power outlet socket before cleaning.
2. Clean all parts, including the blender/soup jug and lid, in hot soapy water and soft cloth. Do not use
abrasive products or wash it in a dishwasher.
3. Clean the electric motor unit with a damp cloth and never put it into water, other liquids or flush it
with water.
To Next Page
Loading...
