Page 8 of 12
• To install the batteries, first remove the back of the remote control by sliding the
battery cover down, then lift off. The direction to slide off is indicated by a small Arrow.
• Insert the batteries inside the battery compartment matching polarity icons with those
in the battery compartment and then refit the cover securely.
Battery Type: “1.5V 2 x AAA”
Do Not mix new and old batteries, or batteries of different types (e.g. Alkaline with Non-
Alkaline) in the remote control.
To prevent corrosion, remove the batteries if the remote control will not be used over a
lengthy period.
Point the Remote Control at the control panel as this is the location of the receiver, then
press your desired button.
To Next Page
Loading...
