Interchangeable Massage Heads
Note: For massage head installation, simply plug/pull to remove and replace
different massage heads
Control Panel
1. ON/Off & Speed setting Button:
• Press & hold 2 seconds to switch ON the massage gun.
• Short press to select speed.
• Press & hold 2 seconds again to switch to standby mode; battery
indicator will remain ON.
• Press & hold 2 seconds the third time to turn OFF the massage gun.
2. Speed indicator: 1-5 speed, in white LED
3. Power indicator: 1-4 level, in red LED
Battery low, require charging
1. Please make sure the massage gun is switched OFF before charging.
2. Fully charge the massage gun for 6 hours before first use.
3. The Battery Indicator flashes regularly to show it is under charging.
4. DO NOT use it when charging.
5. The average running time of the massager is about 3 hours, depending on
speed selected and pressure applied. When only 1 indicator is left flashing, it
means the massage gun need charging.
1. Press and hold the On/Off button for 2 sec, the unit will turn ON.
2. Keep pressing the button until desired speed is selected. Speed setting will
cycle through 1-2-3-4-5-0 (standby mode).
3. If reached standby mode (0), wait for 3 sec to start the speed setting cycle
again.
4. The unit will automatically turn off after 8 minutes of operation. It is
recommended to allow the massager to cool down when the enclosure is
warm to touch.
5. Restart the unit by pressing & holding the ON/Off button after auto-shutdown.
Maintenance, Cleaning and Storage
1. Clean the equipment with a slightly damp cloth and dry with a soft cloth.
2. When storing or traveling, put it in the package provided.
To Next Page
Loading...
Need help?
General
