anko MITYFLEX 907 Series - Component Maintenance and Selection; Roller and Tubing Compatibility; Fuse Installation for Model 907; Fan Assembly Instructions

6

ROLLER/TUBINGSELECTION
UsethefollowingcolorcodedrollerswiththeappropriatetubingI.D.Yourunitisassembled
withblackrollers.Redrollersareincludedinyourtubingkit.Seeseparateinstructionsfor
rollerreplacementenclosedinyourtubekit.

Roller TubingID ML/Revolution
Black 1/4”(.250) 3.5
Black 3/16”(.187) 2.1
Red 1/8”(.125) 0.8
Red 1/16”* 0.21

*The1/16”IDtubingmustbeinsertedinto3/16”(.187)IDX3/8”(.375)ODtubing(sleeve)for
operationinpump.

FUSEINSTALLATION(907)
(Seepage4forfusetypeandpage10forfuseorderinginformation)
1. Disconnectpowertopump.
2. Removefourscrewsfromcasefront.
3. Carefullyremovecasecoverbeingsurenottopullwiresapart.
4. Laytheunitonaflatsurface.
5. Findfuseholderandpullapart.
6. Removeoldfuseandreplacewithnewfuse.
7. Replacecasecover.

FANASSEMBLY
(Seepage4forreplacementnumber)
Disconnectthepowerfromthepump.
Thefanispressedontotherotorshaft.Onall907caseunits,thefanispressedonwithmetal
clipawayfromthemotor.OnallOEM908units,thefanispressedonwiththemetalclip
towardthedoor.




