EasyManua.ls Logo

Anslut 014756 - TECHNICAL DATA; USE; HOW TO USE; FILLING WITH WATER (THREE METHODS)

Anslut 014756
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
27
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage 220 – 240 V
~
50 Hz
Output 22W
Protection rating II
Volume container 4.5 l
Nominal supplied water 220 ml/h
Noise level 38 dB(A)
Weight 1.18 kg
DESCRIPTION
1. Steam outlet
2. Top cover
3. Water container
4. Control panel
5. Pan
6. Bottom casing
FIG. 1
USE
FUNCTION
1. Place the humidier on a stable, horizontal
surface, at least 2 metres from curtains and
other appliances.
2. Plug in the plug, start the humidier and
check that all the status lights go on for
1 second and then go o. The humidier
is now in standby mode.
3. In standby mode, tap
to start the
humidier in high power mode. Press
again to switch o the heat humidier.
4. When the humidier is running, tap
to adjust the amount of steam. Each tap
switches in the order of medium, low, high,
medium mode. A blue status light indicates
high mode, green medium mode, and
yellow low mode.
5. In run mode, press
to switch on or o
the status light.
6. If the container is removed in run mode,
or the product switches o as a result
of a lack of water, the product goes into
standby mode. The red status ashes for
10 seconds and then goes o. Press
while the light is ashing to switch o
before the 10 seconds have run out.
HOW TO USE
NOTE:
Pull out the plug before lling with
water.
Make sure that water does not get into
the steam outlet when lling.
Do not ll water over the MAX mark.
The humidier switches o
automatically when the water in the
container is used up and the red status
light starts ashing.
If there is no water in the pan, ll with
water and wait 1 minute before starting
the humidier.
FILLING WITH WATER
(THREE METHODS)
The humidier can be lled in three ways.
Use alternative one the rst time the container
is lled.
NOTE:
Before using for the rst time, remove the
foam plastic cover from the oat.
Alternative one
1. Remove the top cover.
2. Remove the container.