Anslut 014956 - Page 42

EN
42
The product can dier from
the diagrams in these
instructions. The controls
and functions are the same.
ELECTRICAL DATA
• The technical data for the
product is specied on the
type plate on the back of the
product.
• The plug must be plugged
into a correctly installed and
earthed power point.
• Never modify the plug in any
way. Allow an authorised
electrician to install an
earthed power point if the
plug does not t in the
power point. The power
point must be fused for the
product’s maximum power
consumption (specied on
type plate).
• The power point should be
easily accessible.
• Do not use an extension cord
unless absolutely necessary.
If using an extension cord, it
must be approved for the
product.
• Do not use the product with
a speed controller – risk of
electric shock.
• Do not route the power cord
under carpets etc. Do not
route the power cord under
furniture or other appliances.
Place the power cord so that
there is no risk of treading on
it, or tripping over it.
• Never attempt to open the
product when it is in use.
• Be careful not to touch the
metal parts on the product
when removing the air lter.
• Do not pull the power cord to
pull out the plug.
NOTE:
• Always follow the safety
instructions when using
electrical products. Failure
to follow all the instructions
and safety instructions can
result in the risk of fatal
injury, electric shock, re
and/or serious personal
injury.
• The diagrams in these
instructions are only
intended as illustrations.