Anslut 014956 - Page 43

EN
43
carried out by qualied
personnel.
• Dismantling and waste
management should be
carried out by qualied
personnel.
WARNING!
• Never use other objects or
methods than those
recommended by the
manufacturer to defrost or
clean the product.
• Store the product in a room
without sources of heat,
such as naked ame, LPG
products, electric heaters,
etc.
• Do not puncture or burn.
• Note that refrigerant can be
odourless.
• The oor area in the room
where the product is
installed must be at least 4
m².
• Follow national regulations
concerning gas.
• Keep the ventilation
openings clean and
unblocked.
• Pull out the plug before
cleaning, service and/or any
other intervention.
• All the electrical connections
must be made according to
the wiring diagram on the
middle column behind the
water container.
FUSES
• The circuit board has a fuse
to provide protection from
overcurrent. The fuse data is
printed on the circuit board,
e.g: T 3, 15 A, 250 V (or 350
V).
• Note concerning uorinated
gas
• Fluorinated greenhouse
gases are contained in
hermetically sealed products.
For specic information on
the type, amount and carbon
dioxide equivalent in tonnes
of uorinated greenhouse
gases (some models), see
marking on product.
• Installation, electrical
connection, service,
maintenance and repairs to
the product should be