Anslut 014956 - Continuous Drainage; Maintenance and Cleaning; Cleaning the Air Filter; Cleaning the Water Container

EN
49
2. Continuous drainage
The water can be drained automatically to a
drain with a hose with a diameter of 16.5 x
13.5 mm. Hose included.
1. Remove the drain plug on the back of the
dehumidier and put it in a safe place.
2. Connect the hose.
3. Check that the connection is tight.
4. Put the end of the hose in a suitable
drain. The drain must be lower than the
outlet on the dehumidier. The hose must
go down towards the drain. Avoid pulling
the hose.
FIG. 7
NOTE:
• Remove the hose and insert the rubber
plug when the hose is not in use.
• The hose must go down all the way
towards the drain.
• Do not fold or bend the hose.
MAINTENANCE
MAINTENANCE AND CLEANING
Switch o the dehumidier and pull out the
plug before cleaning.
Cleaning the grilles and casing
• Use water and a mild detergent. Do not
use strong or abrasive detergents.
• Do not expose the dehumidier to
splashing water – this can damage the
insulation and result in a risk of electric
shock and/or cause corrosion.
• Clean the grilles for the air intake and
outlet with a vacuum cleaner or brush.
Cleaning the water container
Clean the water container every two or four
weeks to prevent the build-up of mildew and
bacteria etc. Pour a little fresh water with
mild detergent into the water container, swish
around, pour out and rinse.
NOTE:
• Do not wash the water container in a
dishwasher.
• Check after cleaning that the water
container is properly inserted, otherwise
the dehumidier will not work.
Cleaning the air lter
Check and clean the air lter, which sits inside
the front grille, at least every other week.
NOTE:
Do not wash the lter in a dishwasher.
Removing the air lter
1. Pull out the water container.
2. Press the ap on the lter inwards a little
to release the lter from the holder, and
then pull down the lter.
FIG. 8
3. Clean the lter with hot soapy water.
Rinse and allow to dry before tting. Do
not wash the lter in a dishwasher.
Fitting the air lter
1. Put the lter in the dehumidier, press the
ap inwards and press up the lter.
2. Replace the water reservoir.
NOTE:
• Clean the casing and front with a soft,
oil-free cloth, or with a cloth moistened
with a mild detergent. Rinse and wipe
dry.
• Do not use strong abrasive detergents,
wax or polish on the front of the casing.
• Clean the control panel with a dry or
lightly moistened cloth. The penetration