Anslut 014957 - Page 73

EN
73
unless absolutely necessary.
If using an extension cord, it
must be approved for the
product.
• Pull out the plug before
cleaning, service and/or any
other intervention.
• All the electrical connections
must be made according to
the wiring diagram on the
middle column behind the
water container.
FUSES
The circuit board has a fuse
to provide protection from
overcurrent. The fuse data is
printed on the circuit board, e.g:
T 3, 15 A, 250 V (or 350 V).
Note concerning uorinated
gas:
• Fluorinated greenhouse
gases are contained in
hermetically sealed products.
For specic information on
the type, amount and carbon
dioxide equivalent in tonnes
of uorinated greenhouse
gases (some models), see
marking on product.
• Installation, electrical
out in accordance with the
recommendations on the
manufacturer. Maintenance
and/or repairs that require
other qualied personnel
must be carried out under
the supervision of a person
competent to handle
ammable refrigerant.
ELECTRICAL DATA
• The technical data for the
product is specied on the
type plate on the back of the
product.
• The plug must be plugged
into a correctly installed and
earthed power point.
• Never modify the plug in any
way. Allow an authorised
electrician to install an
earthed power point if the
plug does not t in the power
point. The power point must
be fused for the product’s
maximum power
consumption (specied on
type plate).
• The power point should be
easily accessible.
• Do not use an extension cord