EN
90
TROUBLESHOOTING
Cause
The plug is not properly plugged into the power point.
The fuses have tripped.
The set target humidity has been reached, or the water
container is full. The water container is not properly inserted.
The dehumidier has not been working long enough.
The air ow to the dehumidier is blocked by furniture or
curtains, etc.
The target humidity is set too high.
Doors, windows etc. have not been closed.
The room temperature is too low (lower than 5°C).
Something in the room is emitting moisture.
The dehumidier is making a lot
of noise
The air lter is blocked.
The dehumidier is tilted.
The surface is not horizontal.
Frost on the evaporator coils This is quite normal. The dehumidier defrosts automatically.
Water on the oor.
Leakage from the hose or connection.
A hose is not connected, but the rubber plug has not
been inserted.
ES, AS or P2 is shown in
the display.
These error and warning codes are described in the control
panel section.
To Previous Page
Loading...
