Anslut 014957 - Settings and Modes

EN
86
Dehumidication, drying, continuous
dehumidication or smart dehumidication.
NOTE:
Drying and smart dehumidication are not
included on all models.
Adjusting buttons for humidity
• The target humidity can be set from 35 to
85% relative humidity in steps of 5%.
• Press the (-) button for lower target
humidity.
• Press the (+) button for higher target
humidity.
Adjusting buttons for timer
Use the up/down buttons to set the time for
automatic start and automatic stop from 0.0
to 24.
FAN button
Used to set the fan speed. Press repeatedly to
switch between LOW, MED and HIGH modes.
The status light indicates the set mode. In HIGH
mode the status lights LOW and MED go on.
TIMER button
Press to activate automatic start and automatic
stop. Used together with the buttons (+) and ( - ).
Display
The set humidity is shown between 35
and 85%, or the time for automatic start/
automatic stop (0–24), when adjusting. This
is followed by the actual humidity (precision ±
5%) between 30 and 90% RH.
Error and warning codes
AS – error from moisture sensor. Unplug and
plug in the plug. Contact the retailer if the fault
persists.
ES – error from temperature sensor. Unplug
and plug in the plug. Contact the retailer if the
fault persists.
P2 – the water container is full or has not
been properly tted.
Empty the container and insert properly.
Other functions
Indicator light for full water tank
Goes on when the water container is full, or
not properly inserted.
Automatic switching o
The oat switch switches o the dehumidier
when the water container is full, or not
properly inserted, and when the water
container is taken out. On some models the
oat continues working for 30 seconds.
Automatic defrosting
If frost forms on the evaporator coils the
compressor will switch o, and the fan will run
until the frost has melted.
NOTE:
During automatic defrosting you can hear a
noise from the owing of the refrigerant.
This is quite normal.
Start delay 3 minutes
When the dehumidier has been stopped it will
not start for 3 minutes. This is a safety function,
and is completely normal. The dehumidier
starts automatically after 3 minutes.
Automatic restart
When the power supply is reset after a power