Anslut 014957 - Operational Guidance

EN
87
failure the dehumidier restarts with the
previously set function.
Setting the timer
• Press to activate automatic start and
automatic stop. Used together with the
buttons (+) and (-).
• When the dehumidier is running, press
the TIMER button to activate the
automatic stop function. When the
dehumidier is switched o, press the
TIMER button to activate the automatic
start function.
• Press in the UP or DOWN button to
change the time, in steps of 0.5 hours up
to 10 hours and steps of 1 hour from 10 to
24 hours. The control system counts down
the time to start/stop.
• The set time is shown for ve seconds
then the display automatically returns to
show the current humidity setting.
• You can stop the countdown at any time
to start/stop by switching o or starting
the dehumidier, or by setting the time
to 0.0.
• The function for automatic start and
automatic stop is deactivated if the code
P2 is shown.
Drying (some models)
The dehumidier works with maximum
dehumidication in drying mode. The fan runs
at top speed.
IMPORTANT:
• Do not cover the air outlet – risk of
overheating that can result in re and/
or material damage.
• Do not put wet garments that can drip
water on or over the dehumidier – risk
of electric shock and/or material damage.
HOW TO USE
Positioning
The dehumidier has little dehumidifying eect
in adjacent separate areas without good air
circulation.
• Do not use the dehumidier outdoors.
• The dehumidier is only intended for
household use. It is not intended for
industrial or commercial use.
• Place the dehumidier on a level, stable
surface that can support the weight of the
dehumidier with a full water container.
• Leave at least 20 cm of free space on all
sides to ensure the adequate circulation
of air.
• The lowest operating temperature is 5°C.
At lower temperatures frost can form on
the evaporator coils, which reduces the
performance of the dehumidier.
• Place the dehumidier at a safe distance
from sources of heat.
• Use the dehumidier to ensure a suitable
humidity in the air for books or valuables,
and to prevent damage due to damp.
• Only use the dehumidier in enclosed areas.
• Close windows, doors and other openings.
FIG. 4
Wheel
Do not run the dehumidier over carpets. Do
not move the dehumidier when there is water
in the water container. The dehumidier can
tip over, and the water run out.
• When using the dehumidier for the rst
time it should be switched on
continuously for 24 hours.
• Operating temperature 5-32°C, humidity
30–80% (RH).
• When the dehumidier has been switched
o it cannot be started for 3 minutes.