Anslut 014957 - Cleaning and Filter Care

EN
89
Cleaning the grilles and casing
• Use water and a mild detergent. Do not
use strong or abrasive detergents.
• Do not expose the dehumidier to
splashing water – this can damage the
insulation and result in a risk of electric
shock and/or cause corrosion.
• Clean the grilles for the air intake and
outlet with a vacuum cleaner or brush.
Cleaning the water container
Clean the water container every two or four
weeks to prevent the build-up of mildew and
bacteria etc. Pour a little fresh water with
mild detergent into the water container, swish
around, pour out and rinse.
NOTE:
• Do not wash the water container in a
dishwasher.
• Check after cleaning that the water
container is properly inserted, otherwise
the dehumidier will not work.
Cleaning the air lter
Check and clean the air lter, which sits inside
the front grille, at least every other week.
NOTE:
Do not wash the lter in water, or in a
dishwasher.
Dismantling
• Grip the tab on the lter and pull up and
then out.
• Clean the lter with hot soapy water.
Rinse and allow to dry before tting. Do
not wash the lter in a dishwasher.
Fitting
First put the bottom edge of the lter in the
dehumidier, then the top edge.
FIG. 7
IMPORTANT:
Never use the dehumidier without a
lter – dust and impurities will reduce the
performance of the dehumidier.
NOTE:
Clean the casing and front with a soft, oil-free
cloth, or with a cloth moistened with a mild
detergent. Rinse and wipe dry. Do not use
strong abrasive detergents, wax or polish
on the front of the casing. Clean the control
panel with a dry or lightly moistened cloth.
The penetration of water can cause the
electronic components to stop working.
Withdrawal
If the dehumidier is not going to be used for
some time.
• Switch o the dehumidier, and empty
the water container after one day.
• Clean the dehumidier, the water
container and the air lter.
• Cover the dehumidier with a plastic bag.
• Store the dehumidier upright in a dry
well ventilated place.