AFTER USE
Page 8
After any operation, return the monitor to the standby position by
completing the following steps.
1. Turn off main water supply.
2. If operated manually, complete steps a and b.
a. Realign hole in monitor base with hole in chain sprocket.
Insert release pin fully into aligned holes to engage monitor
base to oscillating mechanism (2 in. pin engagement for
WOM-3 monitor/3 1/2 in. engagement for WOM-4 monitor).
b
. Return selector valve handle to RUN position (pointed to
back of enclosure).
3. Using handwheel (WOM-4) or tiller bar (WOM-3), return
monitor to desired elevation. On WOM-3 monitors, tighten
speed ball handle.
4. Clean filter element as indicated in Step 2 on Page 9.
5. Replace any broken or missing visual inspection seals at
release pin, selector valve handle, WOM-4 elevation hand-
wheel, or WOM-3 speed ball handle.
To Next Page
Loading...