Antar AT51112 - Rollator Folding; Folding Procedure; Using the Rollator Seat; Safe Sitting Precautions

- 9 -
IU_ AT51112
ENG
1. 2. 3. 4.
Folding
All of the above steps must be performed in reverse order.
Sing on the product
When using the AT51112 rollator to sit on it, strictly follow the precauons on page one, in
parcular:
1. Make sure the parking brake is blocked.
2. Do not use the seat without the backrest folded to the correct posion.
3. Do not use the seat if the rollator is on a sloped or uneven surface.
4. Do not exceed the maximum user weight.
5. Do not use the rollator as a wheelchair.
Checking and using the brakes
1. Before using the rollator, always make sure that the brakes are fully funconal.
2. Check the operaon of the brakes by pulling up the brake levers as shown in Fig. 3 - the
rollator should not move.
3. To block the parking brake, push the brake levers down. An audible click means the brake is
in the correct posion - the rollator should not move (see Fig. 4). Note that both levers must
be in down posion when using the parking brake. To release the parking brake, the levers
must be moved up.
4. If the rear wheels of the rollator connue to move aer blocking the parking brake or
pulling up on the brake lever while walking, stop using the rollator immediately. It must not
be used unl the brakes have been checked and adjusted. See maintenance secon.
3 4