Antari M-11 - Technical Label Information; Fluid; Setting up

6
© 2023Antari Lighting and Effects Ltd. www.antari.com
5. Technical Label Information
Read the information on the technical label before operation.
Technical label is attached on one side of control panel.
1. Model Name
5. Breaker
2. Input Voltage
6. QR CODE for User Manual
3. Frequency
7. Serial No.
4. Rated Power
6. Fluid
CAUTION!
Always disconnect from the mains before filling the machine. Never add flammable
liquids. If fluid gets inside the machine, please contact your local Antari dealer for
service.
Only use Antari designated fluid for the Antari Fog Machine. The machine is tested and calibrated with
this liquid to get the best output performance. Warranty will be void if any other type of liquid is used,
improper use of liquid may lead to machine failure and malfunction.
7. Setting Up
CAUTION!
Risk of injury caused by falling objects.
Make sure installation location, fastening connecting and rigging hardware can hold
at least 10 times the weight of the machine.
Make sure that the machine is installed securely and cannot fall down.
It will cause severe injuries if the machine falling down.
Step 1. Place the machine on a flat surface and in a suitably large area with at least 50 cm open space