Need help?Do you have a question about the Antec Basiq BP350 and is the answer not in the manual?
Details on passive power factor correction (PFC) for EU models, compliant with EN61000-3-2.
Explanation of the power switch and its use with the computer's software.
Steps to prepare for installation: power off, open case, disconnect old PSU.
Check and set the voltage switch to match local power supply.
Connect 24-pin and 4-pin +12V connectors to the motherboard.
Connect peripheral power connectors to drives and optical devices.
Connect SATA drives, close the computer case.
General| Wattage | 350W |
|---|---|
| Form Factor | ATX |
| Efficiency | 70% |
| Input Voltage | 100 - 240V |
| Input Frequency | 50 - 60Hz |
| +12V Rails | 1 |
| Cooling | 120mm fan |
| Main Connector | 20+4 pin |
| SATA Connector | 2 |
| Molex Connector | 3 |
| Peripheral Connector | 1 |
| Floppy Connector | 1 |
| MTBF | 100, 000 hours |
| CPU Connector | 4-Pin |
| PCI-Express Connector | 1x 6-Pin |
| Protection | OCP, OVP, SCP |
| Input Current | 6A @ 115VAC, 3A @ 230VAC |
| Dimensions | 150mm x 140mm x 86mm |
To Next Page
